Light weight stainless nicely formed and polished with lots of fixing options! The recess where your number plate sits is almost deep enough to retain the number flush to the bezel. My only gripe is that the returned edge of the pressing is sharp. If the number plate holder is mounted on a flat surface no problem, if it's mounted on a bumper where the edges are effectively exposed you'll need to be careful when washing or cleaning behind it. I'd still recommend them and buy them again. I'm going to gently debur and remove the the sharp edge with a fine file.
Verified purchase: Yes | Condition: New
I picked this holder out of a sea of plate holders on EBay. It does the job, but, it’s very sharp on the back edge and you will need to be carful handling it. Fitting is straight forward, make sure you use stainless steel screws. I’ve also run a bead of sikaflex on the back edge so it didn’t mark the paintwork on my vehicle.
Verified purchase: Yes | Condition: New
Hi quality stainless steel pressing which shines really well of you give it an additional polish. Very pleased, would buy again.
Verified purchase: Yes | Condition: New
I bought these for my 2018 E Class Merc and they arrived very quick and were well packaged. Each piece was individually protected with clear film. On my car the mounting holes did not align with the pre cut slots in the plate. I used a round file to open up the adjacent slots to my mounting holes and this worked a treat. The plates could do with more selection of mounting holes to fit a wider range of cars but you can overcome this with a file. The rear plate fitted quite easily but there were no sticky pads or double sided tape included in the kit to attach the plastic reg plate so you will need to buy these in advance. The front plate on my car is curved so the plate needed to be gently bent into shape. This worked well with no deformation of the plate profile provided the bend is done very slowly and little by little. There were no sharp edges on these plates so handling was safe and no cuts were experienced. Once the plastic film was removed the mirror finish was very good and these look very professional when fitted. Highly recommend paying the higher price for these if you want quality and no sharp edges for handling. As long as you have your own fitting pads etc these are a great item to show off you Reg plate. Read full review
Verified purchase: Yes | Condition: New
My second set of these for different cars. It really sets off new pressed number plates and looks superb. My first set is now two years in use and still looks like its just been fitted. Its pressed sheet stainless steel so it does have sharp edges. You could spend a few minutes de-burring them or just use something like gardening gloves when handling. They are perfectly straight and I needed a slight curve on the front plate for both cars. With a bit of patience and care I managed that (10mm rise from edge to middle) using a heat gun on high (450c) to help de-stress the metal and slowly add small bends every 100 or so millimetres along the length. I used stainless steel screws and washers to fix them in place with a small amount of double sided tape as backup.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Number Plates & Surrounds
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Number Plates & Surrounds