The tiny bottle comes with a brush attached to the lid and this makes it easy to apply. I put the bottle in a small glass to prevent it getting knocked over. Although the bottle's small the liquid goes a long way and it does the job nicely, even with low or zero lead contents solder.
Verified purchase: Yes | Condition: New
I have not actually tried it for surface mounted devices yet. However I have been using it for repairing old "tag-strip construction" radios and similar equipment. It is particularly useful for re-soldering dry or broken solder joints. Brush on a little of this stuff, apply a few millimetres or so of new solder and you have a perfect joint, in seconds. Joint is nice and shiny and there is very little residue. Unexpectedly, I find it quite useful for de-soldering too. Removing a wired potentiometer or socket is much easier if one first coats the joint s with a little of this stuff. The melted solder flows nicely up the solder sucker, leaving the joint clean and making the wire easier to remove from the hole. I only bought a 50ml bottle because I was not sure how effective it would be. But now I have used it successfully, I plan to order a larger one shortly. Read full review
Verified purchase: Yes | Condition: New
To be honest I wasn't expecting too much from this product since most of the professionals seemed to be using paste syringes. But for the cost, I thought I would give it a try. Well I'm very impressed! Its easy to apply to very specific areas with a small artists brush, so reducing waste and clean up. Quality of joints is as good as anything I've used. Highly recommended.
Verified purchase: Yes | Condition: New
Have been using soldering paste up till now. was watching YOUTUBE tv repair the guy was using liquid for soldering. he said it was a lot better than pasts as you can see what your doing, so thought I would buy it. and he was right, it so much easier to you and you also can see what your doing
Verified purchase: Yes | Condition: New
Received this today and tried it out on some pcb soldering one tiny little drop on the component and board and the joint came out perfect also tried it on Arduino nano self assembley header pins and again it worked a treat great tool to have next will try soldering etched brass fittings on my model boat
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Soldering Flux
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Soldering Flux
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
