Not a bad little set, ok to round dented tailpipes, exhausts, but will only increase/flare pipes slightly-not heavy duty. Manufacturer should use steel springs to hold them together instead of rubber o-rings as obliviously you’ll need to heat pipe as you expand, rubber o-ring and heat don’t mix. Did want I needed of them which was to round and expand an exhaust section by approx 1mm to make it accept an aftermarket stainless steel section. All in all a handy tool for little money but wouldn’t tackle anything serious with them.
Verified purchase: Yes | Condition: New
The plastic pipe that fits to the outlet neither fits inside the hole or outside as it is too small to fit outside. Supplier gave a 50% refund and I 'modified' the pipe to make it useable. I cut the pipe and fitted over the outlet, made a small piece of plastic to cover gap and then glued on. taped up outlet pipe exit area and it works ok now.
Verified purchase: Yes | Condition: New
ordered 2 sets and struggled to get wheels on, 1 stand cannot be used as only got 3 out of 4 wheels to fit.
Verified purchase: Yes | Condition: New
The product is nice but some of the panels dont line up you have to do the best you can it covers a lot of bad parts on the walls your product is better than the one I got before Regards Ronnie
Verified purchase: Yes | Condition: New
No recommended for stainless steel exhaust pipes, 1mm increase at the most even when heated. May work better on mild steel.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Business Signs