 |
This was bought specifically to glue foam padding into a carbon fibre freestyle kayak. It worked. Other bonding agents didn’t (we tested first, so no harm done, other than wasted time and money). No chemical interactions or refusal to adhere to either material (carbon or foam). The stuff mixes very easily and spreads well - a butter knife or plastic spatula will do the job. We used duct tape to hold in position, weights to maintain pressure and left it completely alone for 24 hrs. It is fairly expensive for a small amount. We required most of 2 packs and would probably have slathered it on more generously if we hadn’t seen early on that we wouldn’t have enough to complete the job if continued that way. Important to reiterate: It worked. The kayak has been out on the water for a total of 6 hours and no part of the foam is coming loose. Recommended. Unlike so many things this does what it promises to do.Read full review
Verified purchase: Yes | Condition: New
I am a homebrew radio amateur and often repair diecast boxes to reuse. This has been with araldite in the past.I find that your Marine Weld keys better to the metal, sets harder to give a very clean finish using electricians insulating tape as shuttering and you get about twice as much for your money!
Verified purchase: Yes | Condition: New
Purchased to repair damaged waterfeature which has bee achieved £ 100%.Its the exact colour match to the slate stone on rockery & waterfeature.Heatwave has flaked off paint on one waterfeature & exposed different coloured fibreglass beneath.Have colour matched damaged areas by using product not as a glue but a paint on seal to great effect.
Verified purchase: Yes | Condition: New
simple to mix, spreads well- bought it for one particular job on my boat, but have used it on various items needing glue repairs. great all round resin .
Verified purchase: Yes | Condition: New
I use this as pretend welding, I warm the tubes in hot water, then when mixed put in a syringe. Then I weld by squeeze,,pull,squeeze, pull along the line where i want the weld. It's very effective on the aluminium model Ribs that I build. It helps to scratch the contact area.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Adhesive Tapes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Adhesive Tapes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
