Picture 1 of 2
![Stock photo](https://i.ebayimg.com/images/g/a4AAAOSwfeVg3HhI/s-l640.jpg)
![BOND IT PU18 Marine polyurethane Adhesive sealant marine Pond GRP high strength - Picture 1 of 2](https://i.ebayimg.com/images/g/42wAAOSwmEBmKnS8/s-l500.jpg)
![BOND IT PU18 Marine polyurethane Adhesive sealant marine Pond GRP high strength - Picture 2 of 2](https://i.ebayimg.com/images/g/5gsAAOSwGR5mKnTD/s-l500.jpg)
Picture 1 of 2
![Stock photo](https://i.ebayimg.com/images/g/a4AAAOSwfeVg3HhI/s-l640.jpg)
![Picture 1 of 2](https://i.ebayimg.com/images/g/42wAAOSwmEBmKnS8/s-l1600.jpg)
![Picture 2 of 2](https://i.ebayimg.com/images/g/5gsAAOSwGR5mKnTD/s-l1600.jpg)
Cheaper alternative to some other brands, seems to do the job just fine so far. Not much you can really say but it does what its supposed to do, hopefully stands the test of time but will have to see. Seems to have a good bond strength though and fairly quick curing without being too quick.
Verified purchase: Yes | Condition: New
Used very small amount of product and revealed with supplied cap But on trying to use later it would not gun. This was due to product curing inside tube so unable to gun. Should be a good product. But maybe just a dodgy batch. Note experienced user of sealants and take great care to store in correct temperature and to reseal as much as possible. Caps usually do the job. The sealant in the actual nozzle had not hardened at nozzle end but about 10mm had gone hard into tube. The only thing that comes to mind is this comes in an aluminium tube not plastic. So not sure about nozzle to tube. Looks like threaded properly and well sealed. But this seems to be where problem is. Either that or some had gone hard in tube and was forced into exit point and nozzle preventing it to gun. Have contacted seller but no responceRead full review
Verified purchase: Yes | Condition: New
Good product and I have used PU sealants of this type before such as Tiger Seal and other brands but this one performs the same for my needs and is a little cheaper. Also more convenient as it is delivered free rather than having to go and collect when needed!
Verified purchase: Yes | Condition: New
I have used this in a homemade wooden mould to make a gasket for a Landrover rear light. I tried several and PU18 had the best texture. Left it for two days before peeling . Only time will tell whether it lasts for the next 62 years.
Verified purchase: Yes | Condition: New
Great adhesive qualities and cheaper than main brand stuff such as sikaflex or 3m alternatives. Dries fully overnight but ok after a few hours .nice finish and workable from the tube .
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Adhesive Tapes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Adhesive Tapes