Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Cooking Appliance Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Cooking Appliance Parts
My 6 year old Frigidaire , oven stopped working, I ordered a new Electrolux igniter , it was super easy to replace, it took about 10 minutes, bottom line is it works better than new, and I now don't need to buy a new range, I highly recommend this product to anyone who is experiencing oven problems, not lighting, not achieving proper temperature, or gas odor. I would definitely buy this part again, if needed.
Verified purchase: Yes | Condition: New
This replacement igniter worked great in my Frigidaire FGF326ASC. It came with the ceramic wire nuts for installation. This splice was ok, but if I had the chance you could rewire the igniter to replace the original with a high temp disconnect and a high temp bullet (not sure of the size/type) that goes inside the original connector. Overall, make sure you cut the wires 2" longer than you think you need to allow for the splice with the ceramic nuts to flex a bit. Not too hard of a job to tackle.
Verified purchase: Yes | Condition: New
When the original manufacturer of my oven decided to refer me different directions in regards to never ending searches of part numbers, I researched as much information on general igniters. Then I realized that there are only two different types and one must be aware of the one being replaced. So EBAY searches led me to numerous sellers and items that qualifies. Some costing as much as $120! When I saw this Electrolux and the seller looks very reputable, I decided to take a chance on purchasing. No regrets whatsoever!! Item satisfies parameters and works like a charm! Will buy again, no second thoughts!!
Verified purchase: Yes | Condition: New
Frigidaire oven was taking forever to heat up because of the faulty ignitor. Replaced with this OEM part and it lit in seconds and heated up like it was new. No problem clipping the wires and using the included ceramic wire nuts. It was much faster than digging deep into the oven to get to the plug. Just clip and connect one corresponding wire at a time. Picture is of first light and flame catching around the burner.
Verified purchase: Yes | Condition: New
My wife had been complaining that her gas oven was taking a loooong time to both start up AND heat up-- and once it did she said it sounded like a Vega with a bad idle. She was fed up using it and went on strike. I got hungry. I got busy. Upon initial investigation I found the igniter was on it's last leg. McComb's had EXACTLY the part I needed which I promptly ordered and installed on the day of arrival. VIOLA! The oven was fixed, the strike ended, and I now get to enjoy baked goods once again! Life IS good!!
Verified purchase: Yes | Condition: New
Works perfectly! Original, factory-installed ignitor finally failed on my 2002 Whirlpool Gold Series 30” slide-in gas range. Replaced with this part and my range is back in action! It’s been installed for a month now and I’m very happy with it. I suggest pulling out the old, fried ignitor and taking a look-see - it’ll be round or flat shaped. Then, do an internet search for like and kind. It’s such a generic part, if it looks the same, it should work just fine. There are no instructions, but YouTube videos make the install procedure easy-peasy. I simply clipped off the old ignitor plastic plug-ins & wired the wires to the 2 bare wires on the new ignitor; using my own wire-connectors & shrink-wrap tubing - about 17” away from the ignitor, located thru the range’s back panel wall. I re-used the old-wiring insulation - it must have been installed for a reason. Then I screwed the ignitor back in - fired it up & couldn’t help smiling at the quick-fix that just saved me thousands of dollars on the purchase of a new range. Excellent deal!Read full review
Verified purchase: Yes | Condition: New
Installed real easy and worked like a charm! After I installed this part, I turned on the oven and immediately it glowed bright orange and the oven lit without hesitation. I definitely would recommend this product to anyone looking to replace their part, instead of going out and buying a new range!
Verified purchase: Yes | Condition: New
Oven igniter worked perfect in my Maytag range, although I knew that I would need to remove it from the new bracket and install it in my original bracket. The new bracket was not the same as the original. Again, I knew this from the start. I just needed the igniter. The igniter was exactly the same as original. Great price, easy swap , works as it should. J.L.W.
Verified purchase: Yes | Condition: New
Whirlpool Gas Range Oven was taking 3 minutes or more to light. This was causing uneven baking temps and extended baking times. Now it lights in 30 seconds and baking is back to normal. Great purchase, I will buy again, as theses igniters last only 3 to 4 years in heavy uae. My range is 4 years old and to be able to fix it for $12.98 is a great deal.
Verified purchase: Yes | Condition: New
This is the second time in only a few months I have had to replace this on this stove... original lasted 10+ years and then 1st replacement failed in a couple months... this one working great so far... will update after a year to bump up a star if it lasts, and will downgrade if it fails.... price point and initial quality good though
Verified purchase: Yes | Condition: New