Picture 1 of 3
Stock photo
Picture 1 of 3
Stock photo
Gunson G4062 Eezibleed Brake Clutch Bleeding Kit
Price:
£30.00
+ £4.00 postage
Returns:
Condition:
 | Shop by category |
{"delay":300}
|
Really does make bleeding easy, I had totally failed to bleed the brakes after replacing the master cylinder; 10 minutes with this gadget, & all is well. My only criticisms: 1. After the job, the reservoir will be over-full. A plastic pipette would be handy to reduce the level to the mark. 2. Once you have used it, it will drip brake fluid, & cannot be stored in its original cardboard box. Needs a custom tupperware type box for storage.
Verified purchase: Yes | Condition: New
Bought new in 2016. I tried to use it once at about 15 psi. The clip-on air chuck was junk and leaked so the tire went flat before you could bleed one wheel. It was also leaking around the cap so I figured that I needed to check the gasket. I bought a screw-on shrader connector. That cured my tire valve problem but while testing, the large container for the brake fluid has a pinhole in it. I contacted Gunson and they can special order one for about $40 with shipping. Cheaper to buy a new one. Great idea but they are using junk materials to put them together. Too bad.
Verified purchase: Yes | Condition: New
Trying to use the easy bleed proved anything but easy because I could not get a good seal on the master cylinder of a 1970's Triumph car with a Girling master cylinder. Despite the Gunson cap fitting, but rather loosely it would not stop the air leaking. I think that the rubber seal is too hard and despite screwing it down as hard as possible air still escaped from the cap top. In the end I managed to solve the problem by winding a lot of cling film around the lip of the master cylinder. It was a job that should have taken 3o mins and ended up taking nearly two hours and a load of frustration.
Verified purchase: Yes | Condition: New
this product is easy to use for one person brake or clutch bleeding jobs,easy enough to reconnect a longer tube if needed to be adapted,the main parts are the oil bottle the schraeder connector and master cylinder caps and catch bottle ,only clear plastic tube left in product which makes it great for customiseing the tube lengths to suit the users needs.
Verified purchase: Yes | Condition: New
This is a direct replacement for the same item (only with plastic instead of metal tops) I have been using for some 40 years, how's that for reliability. It is so easy to bleed brakes and hydraulic clutches with this tool. I have just used the new one after changing flexible and solid brake pipes on a VW D4 and the results are perfect as only DOT 4 can get in and no air.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Brake Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Brake Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
