Crea tri-flow tap has a high quality finish but may require new fittings
The matt stainless steel finish is of a very high quality. Fitting to the sink is also firm using a washer and a screw on plate with screws to apply final pressure to the washer. The cold to hot is via a lever that moved from upright (cold) to down (right angle) for hot normally fitted on the right hand side. The previous tap was 45 degrees either side of vertical, which I prefer.
The hot and cold pipes require a 15mm/0.5 inch coupling. The drinking tap terminates in a push fit 1/4" and in the box is a 1/4 inch pipe with a 1/2" plastic nut. I need a 3/8" Push Fit x 1/4" Push Fit Reducing Straight Connector for the filter.