 |
Good replacement to the standard build bed. Be careful to adjust the height prior to re-levelling as the glass is a fair bit thicker and it's very easy to gouge the surface with the print nozzle. (yes I did just that) Takes a bit longer to heat the bed up and you do need to let it cool to remove the print by simply pulling at it. Dont use metal tools either as this will damage the finish . Bed levelling is critical to get good adhesion. As with most beds, you need to get that first layer squeezed down.
Verified purchase: Yes | Condition: New
This seemed like a good replacement so I gave it a shot. Needs slightly larger bulldog clips to hold onto the heated bed (these should be provided) but works like a dream. Prints stick really well when it is heated and when it cools the parts just fall off. Amazing. Also helps level out a slightly imperfect heat bed.
Verified purchase: Yes | Condition: New
A superb addition to your 3d printer, the surface is smooth, enabling a great finish to your prints.
Verified purchase: Yes | Condition: New
Does what it says. It will mark the top surface but only because the of an initial low hardness surface (stated in listing). Does not affect adhesion. If prints suddenly stop sticking then just clean. Typical mark you can expect are in photo and are perfectly normal.
Verified purchase: Yes | Condition: New
The metal print bed on the Ender 3 pro isn’t very flat, it was a bit proud in the middle even when brand new - the glass plate solves this plus it’s easy to release the printed article
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in 3D Printer Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
