Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Other Jewellery Care, Design & Repair
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Jewellery Care, Design & Repair
Came with 2 tips, which you carefully pull off (I used pliers) to change. designed for light use, easily marks plastic and wood and aluminum. OK value at just over 2 quid delivered. So far I've marked about 20-30 items, using larger tip which still seems fine for at least as much again. perhaps more. You don't need to use force, just light contact. Would expect life of the tip to be short if used on steel. The large tip allows letter height less than about 1/3 inch /8mm. to be engraved quickly in the softer materials as above. The small tip allows letters down to about 1/10 inch or even less.
Verified purchase: Yes | Condition: New
Purchased this to engrave some items for my little girl to give to her Dad. The item was shockingly bad. At first it took me forever to get it to work, then after a little bit of persuasion and bending the metal spring I managed to get a connection for all of about 5 mins. Now it is so intermittent I had to give up with the engraving and go and buy something else.
Verified purchase: Yes | Condition: New
Verified purchase: Yes | Condition: New
easy to use with a good grip handle and different angles to get in all the corners thanks
Verified purchase: Yes | Condition: New
Good product at a really good price,easy to handle. Have purchased a couple as they do a brilliant job.
Verified purchase: Yes | Condition: New
Great product does exactly what it says you can do easy to use just perfect.
Verified purchase: Yes | Condition: New
Can't complain at that price. It works as described, takes a little getting used to. Engraves quite lightly, for a deeper finish you can just go over it again
Verified purchase: Yes | Condition: New
Very flimsy, not at all well made, the small plastic button that activates the tool when in use fell off. When pushed back in, the tool fails to operate properly - the button constantly falls out. This product does not do the job it is intended for
Verified purchase: Yes | Condition: New
Good, but it could do better with two way switch without having to leave thumb/finger on or off the button, without having to grip too long on the button! the front end near the bit just a wee bit thick needs to be more tapered & I notice the bit are not removable or changeable? otherwise it's reasonably good, 80/100.
Verified purchase: Yes | Condition: New
What a load of rubbish this is , it was supposed to be an engraving tool , it would not engrave paper let alone glass ! Which was stated , well it's probably living it's life in land fill !!! What a waste of money
Verified purchase: Yes | Condition: New