Used this inside my 1977 Alfa 105, durring the rebuild. This cloth tape is a pleasure to work with tears easilt by hand, takes shape with minimum effort so much better than vinyl. This version is however not suitable for under car or under bonnet areas use the slightly more expensive 51026 tape as it is heat ,oil, fuel and moisture resistant,. The extra resistance means it has to be cut with scisors but it is very strong and very easy to work with.
Verified purchase: Yes | Condition: New
I would have liked the tape to be a bit stickier, however it is ok for it's intended use which is to cover wiring. If you want to use it to stick to other surfaces then it may not be the best choice. Gorilla tape is a lot stickier, but is not so good for wiring as it's a bit too stiff.
Verified purchase: Yes | Condition: New
Made for tidying vehicle wiring looms, this product is brilliant for the collectors of vintage film cameras. With it's low tack, and exceptional ability to mould comfortably to the shape of vintage cameras, this tape is a godsend when it comes to preventing light leakage. Cameras made from the mid 1960s onwards utilised foam seals to ensure total light exclusion. By now most of these seals have degraded to the extent whereby the camera will let light onto the film. Doubly frustrating as film and it's development isn't cheap, and there's no quick check to see if the exposure is correct as with a digital camera. Using Tesa tape to seal the back of a camera is a simple and inexpensive way to ensure this doesn't occur. It leaves no residue when removed, and doesn't damage the leather covering found on many cameras. Furthermore it's textured finish even aids grip, and if applied neatly is almost unnoticeable. On vintage folding cameras, light leakage from the leather bellows can be rectified in the same manner. While the ideal solution to leakage is to replace the seals, using Tesa tape is a simple and cost effective alternative. Read full review
Verified purchase: Yes | Condition: New
Brilliant product.gives a nice neat OE look to vehicle wiring wether it’s modifying or new install and also gives wiring an extra degree of mechanical protection against abrasion or chaffing against other componants.it’s not the easiest to undo or remove if a mistake has been made so beware but the finished results once wrapped in this product are really good and professional and it doesn’t seem to lose adhesion on smaller wrapped parts like insulation tape over time sometimes does.i use it on all automotive jobs now👌👍
Verified purchase: Yes | Condition: New
Needed it for my car engine bay. Tested it prior to using by trying to set it alight which it didn`t do. Tesa is a very good brand
Verified purchase: Yes | Condition: New
Makes a great job of protecting and tidying up modified wiring looms on my bikes. Easy to work with.
Verified purchase: Yes | Condition: New
Used this after repairing my cars wiring harness. It was super sticky and didn’t wrinkle or look bad. It would conform to the wire and made it look original. Would highly highly recommend for use on cars or any electrical work.
Verified purchase: Yes | Condition: New
strong and easy to use tape, with an all round great "professional" looking finish.
Verified purchase: Yes | Condition: New
This item is exactly as described . It's done the job for me.
Verified purchase: Yes | Condition: New
Precisely the tape for under-bonnet harness, easy to use ans very good quality.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Insulation
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Insulation
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
