 |
Only 4 stars because the rubber for the push rod does not fit. Luckily I had a new rubber already fitted and I used the old push rod. From a positive perspective I used the piston and the seals and my front brake works like new. This is a much more cost effective option than purchasing Honda parts, if you even find them. I would suggest adding a small piece of paper showing which way around to install the rubbers on the piston and any suggestion on how to install the rubbers more effectively without damage.
Verified purchase: Yes | Condition: New
I fitted this cable but both adjusters were maxed out. It looks like the inner steel wire is longer than OEM by about 20mm. Hand lever cable end ferrel was not the correct angle which cause massive strain to the cable angle and binding. Total waste of money. 1983 Honda CX650 C
Verified purchase: Yes | Condition: New
these seals restore much needed vacuum to the crankcase of your S5 2 stroke engine. This engine depends on vacuum from the crankcase to help draw fuel from the carburetor to the cylinder. these seals fit good and install easily. A must have for your Morini s5 engine rebuild.
Verified purchase: Yes | Condition: New
With most of my restoration's being older machines finding correct cables is hard, So making my own is sometimes the only option using the old cable as a pattern.
Verified purchase: Yes | Condition: New
Strongly recommendable. Very good item. Thank you very much for good item selling.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Mirror Assemblies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Mirror Assemblies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
