 |
I bought 1 tin of silver paint and 1 tin of Lacquer to paint a manifold, heat shield, and exhaust system. I just cleaned up the parts to remove loose rust and debris before spraying. If there's any grease on the parts, you need to remove it first. I applied the silver paint first. Went on easy. Just spray in short bursts and shake the can regularly. Allow 10minutes between applying coats. a warm room or sunny day outside allow the paint to dry quicker. Once the paint has dried sufficiently you can next apply the lacquer. This lacquer actually does give a good coat of lacquer. i was able to get at least 3 coats of lacquer from the tin for all the parts. Again apply the lacquer in short bursts, allowing 10-15mins between each coat. Allow the parts to fully dry over night to get the best results. Its quite resistant to runs and i only had a small run bearing in mind i was rushing the job so can't complain. Note: You must use lacquer over the paint to seal it properly, else expect the parts to rust quickly if water gets on them. I recommend this product. It costs a little bit extra but you get a product that actually works and does what it says it will do. It gives very good coverage too. they pack a lot of paint/lacquer into the tin and the entire quantity of paint/lacquer is expelled at the full pressure nice and evenly.Read full review
Verified purchase: Yes | Condition: New
I used this clear coat on my ap calipers that I had already painted. The problem I had was in places there was a reaction between the paint and lacquer, they were compatible but in a few places it bubbled up and wouldn’t cure so I’m having a second attempt
Verified purchase: Yes | Condition: New
I sprayed my crankcase due to flaking chrome, to Matt high temp black, but obviously it will be a nightmare to keep clean as a Matt. Sprayed this over and got a satin which is now petrol and scratch resistant but easier to clean too. My advice is give three coats of this over a high temp paint and your be pleasantly surprised by the quality. Best I've used ... ever . !!
Verified purchase: Yes | Condition: New
Excellent service and products. I used this to revamp my misted plastic headlights after I sanded them with 1200 grit paper. Came back to life as New!! Saved £200 not having to replace the two headlights!! Brilliant products. ;-) Thanks for your help
Verified purchase: Yes | Condition: New
The E-Tech XHT paints and lacquers work exceptionally well, good coverage and consistent finish giving a resilient, durable coating to Engine/Exhaust casings/systems/components. I've used various manufacturers' offering over the years and, find this E-Tech paint very much to my liking.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Other Body Paint & Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Body Paint & Supplies
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
