 |
This product does exactly what it is advertised to do. It is a low cost 8 channel PC based oscilloscope. It does not have great bandwidth so fast moving signals are difficult to see. But if you want an instrument to see what's happening to a multitude of signals simultaneously then this is the right instrument to choose. As it cost less than some multimeters it is a good instrument to keep in your test cupboard. Only downside is it needs some good probes on top of the price you pay as the leads it comes with are only 1 X and difficult to connect to small terminals and circuits.
Verified purchase: Yes | Condition: New
If you buy one of these don't run more than two channels at once as the sample rate is shared between the channel and it isn't fast to begin with but you can do useful car diagnostics with this tool. The bundled probes and connectors are useful for ignition system diagnostics. The software like that on most other Chinese oscilloscopes is pretty awful, on installation it defaults to some form of Chinese. This can be fixed very simple by going into the Hantek software language directory and deleting the Chinese language file. The software layout tries to copy the layout of the controls on a desktop DSO but this makes the software tedious to use with a mouse or touch pad.
Verified purchase: No
Bought this when my verus packed up. It's a good scope for doing basic checks e.g.. cam crank correlation. Lin bus . Fuel pump current ramps and primary and secondary ignition. It will pick up can lines but no where fast enough to get detail off it. Software is ok to use once you get used to it.
Verified purchase: Yes | Condition: New
In my case 4 out of 8 channels were faulty. Photos show those channels being tested by connecting them to test square wave generator with a single probe for each channel and should be showing square waveform for each single channel connected at a time. channels 1 and 2 appear dead and channels 7 and 8 seem to be shorted to other channels as they display waveform for additional channels which weren't connected to the probe. Last photo shows occasional noise of channels 1 and 2 although no probe was connected at that time. Waste of time.
Verified purchase: Yes | Condition: New
this package came with window 10 software. even it a bit tricky to install but not that bad. after installing it correctly it work just fine.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Oscilloscopes & Vectorscopes
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
