 |
I was using this spout on a low profile Land Rover type 5 Ltr can so I needed to file the lever arms slightly for it to engage properly. Its brilliant now.
Verified purchase: Yes | Condition: New
The rubber seal is not held/secured in place and either sticks to the can or falls off onto the ground. Very poor quality and would not recommend it to anyone. Have just found out that by using this piece of rubbish it has bent the original mechanism for securing the lid on tight. This prevents the original lid sealing properly and petrol spilling out around the car. This Gerry can has 30 years of me using it and never leaked a drop until I attach a cheap Chinese knock off which ruins it! Don't waste your money on it, just get a decent tun-dish.
Verified purchase: Yes | Condition: New
Leaks but my local Asda diesel pump also leaks!! Rubber seal not wide enough to stop it falling out. it will eventually get lost. Hit with hammer to tighten also works. Delivered early and well packaged. Would buy again because of good value.
Verified purchase: Yes | Condition: New
This design has an issue with the air bleed hole, it is on the side of the nozzle, obviously it leaks like a tap, so cover it with some tape, and put up with glug glug glug, as the air bleeds back to your can.
Verified purchase: Yes | Condition: New
Great accessory to have for your Jerry can but I feel that the seal could be better as it leaked slightly on the 3 occasions I used it. I have since bought a better seal tested it and it’s fine, other than that well made and I’m quite happy now.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Fuel Cans
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Fuel Cans
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
