 |
very pleased with this product works very well good value for money comes in a very good size tube very pleased
Verified purchase: Yes | Condition: New
I needed this handlebar grip glue to stick down my new Oxford heated grips to my bike. The glue is very thick and when you slide the grip on it pushes most of the glue to one end, which means most of the grip is not stuck down. Sure enough my clutch side grip came loose after my first ride since installing the heated grips. I left the glue to dry for nearly a week. So I tried a second time, and it failed again. I cleaned up the handlebar on both occasions, and applied an even spread of glue. The third time I restored to super glue, which sure enough is nice and thin and has held the grip down perfectly. For some reason this glue worked perfectly on the throttle side, so it have a 50/50 failure/success rate.
Verified purchase: Yes | Condition: New
Don't usually use grip glue but acquired an old Royal Enfield WDCO where both the handlebar grips were loose. Applied some of this when fitting new Oxford Fat Grips, glue stays wet long enough to slide grips on and twist into position before setting hard overnight. Seems to do the job.
Verified purchase: Yes | Condition: New
Used with Oxford heated grips. Strong glue. I used a bit too much and ended up on my actual grip but wiped away. Grip is firmly stuck in place
Verified purchase: Yes | Condition: New
Supersports, heated grips, took 2-3 days to set because it was winter and it has held up.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Grips, Covers & Pads
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Grips, Covers & Pads
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
