Was greatly disappointed with this product. The build quality was bad and the frame was out of square but wasn’t to bothered as long as it functioned. Actually it cut quite well in the test and I was eager to start sending documents through. This is where my problems began the software and installing the device on my pc took over 5 hours to set up very difficult and unclear instructions. finally I got it set up and thought I’d start with a simple logo unfortunately it got halfway through and stopped working. I Tried this again multiple times and even using there software it would stop halfway through (note this is not an issue with static at all) as I learnt the memory is simply not big enough for a plotter of these parameters. I’ve had a Cricut before and it managed fine with logos of a bigger size and far more complexity than this for a similar price ,yes the cutting area is not as big but this cannot cut big vectors nor simple vectors it’s not possible. Greatly disappointed as it cuts very well for the price but it just needs a greater memory capacity . Please do not buy it’s a waste of time and an expensive paperweight.Read full review
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Vinyl Cutters