CURRENTLY SOLD OUT
 | Shop by category |
{"delay":300}
|
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Other Golf Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Other Golf Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
I have a ping Hoover bag, the tubes in standard size raise out of the bag when on its stands, a quick DIY in sizing them (shaved 3 inch) sorted that problem out, the poles are now discreet and do the job well. If you have thick grips they will struggle to house themselves without having down the shaft.
Verified purchase: Yes | Condition: New
The product itself is good quality and came quickly but as they are inserts the club grips catch them and pull them out of the bag. So for me, I was getting them to stop that sticking and pulling different clubs out of my carry bag during a round and it just swapped from clubs pulling out together and sticking to tubes pulling out each and every time and having to be placed back in so didn't add any benefit for me. I used them twice then took them out. There may be a way of attaching them to your bag but this wasn't something I know about so gave up quite easily
Verified purchase: Yes | Condition: New
Good product and good fit in bag. One small thing is that the tubes could all be the larger size rather than 7 that fit inside 7. You can still get the clubs in and out but the smaller ones tend to pull out of the bag. Other than that I would recommend product and supplier
Verified purchase: Yes | Condition: New
The tube diameter is only just large enough for the grip of the clubs, except for my putter where the handle has a slight curve in the design and doesn't fit. It is because they are only just large enough for the others that means you have to remove the club dead square along it's length, otherwise the tube comes out the bag with the club. The design could therefore be much improved upon if it included a generic method of fixture within the sections at the top of the golf bags. I thought of an ingenious use of velcro, but the cost and effort involved without knowing the success put me off, and I've ended up drilling holes towards the top of the tube and screwing each one to the sections at the top of my bag. Simpler and cheaper, but not ideal. Essentially, the tube diameter needs to be at least 30% bigger and possibly incorporates a plastic frame that keeps them from coming out the bag every time a club is selected.Read full review
Verified purchase: Yes | Condition: New
They can be a little porne to cracking around the neck, they will also accelerate wear on graphite shafts at rub point. Ok for steel shafts.
Verified purchase: Yes | Condition: New
