The screwdriver itself seems good quality. The plastic bracket for holding the bits and the screwdriver is rubbish. I don't understand why the bracket was designed like it is and here's why. First of all it seems like it was designed as cheap as possible. It is designed to be screwed to a wall with the screwdriver set in the middle and bits on eigher side. At the bottom of the bracket there is a little bit of plastic sticking upwards so the tip of the screwdriver sets into it. which is simple and seems to work but the top part where the screwdriver clips into is complete and utter pants. Further more where the bits clip into is that tight. That you know whats going to happen dont you ? Yip you got it (It slips and its gone) Thats correct on the floor and if your lucky it will land somewhere where you can see it. Nope of course it doesn't it never does it always hits something on its way down and yip you got it again. Its only gone and landed down in behind something that takes you half an hour to move. Complete and utter Chaos So Stanley not a bad ratchet screwdriver but why the hekk would you make such a dumb peice of plastic bracket to go with this screwdriver and cause us D I Yers so much stress when all we want to do is destress at the wkend by grabbing a screwdriver or some sort of tool to look bisy so the other half doesn't moan at us. WHY WHY WHY would you do this to us . You need to sack the designer who pulled this peice of plastic out of there ear hole. 🙊 Other than that its not bad. ☺Read full review
Verified purchase: Yes | Condition: Pre-owned
The holder is made of cheap brittle plastic and the screwdriver is hard to remove from it when first bought. No instructions for removal either and it’s tricky. Actual screwdriver itself feels less well made than previous models; I guess someone is cost cutting. Disappointing from a brand as famous as Stanley. Think twice.
Verified purchase: Yes | Condition: New
This was bought as a straight replacement for a Fatmax that was broken, by me. Sadly I feel this product is inferior to the product I was replacing. Changes have been made that I feel make this product a poor replacement. A handle that changes direction ??? doesn't seem to have the same bit "attraction" and no room in the handle for spare bits.
Verified purchase: Yes | Condition: New
Good quality and extremely useful using the hex bits for flat pack is so easy in tight places with the adjustable handle.
Verified purchase: Yes | Condition: New
Use this pistol grip most days very well made just right for most thing all round good tool big thanks it's great
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Screwdrivers & Nutdrivers
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Screwdrivers & Nutdrivers