Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best-selling in Switches, Connectors & Wires
You really need to understand what you are doing when charging LiPo batteries indeed any type of battery. However, when charging LiPo batteries using a parallel charging board all batteries need to be exactly the same and the cell voltages between each individual battery really need to be within 1/10 of a volt for safety sake. So check each batteries cell count prior to charging and group them into batteries that can be charged in parallel together. It goes without saying that you should never leave batteries unattended especially LiPo batteries whilst they are charging. A good practice is to use a good hobby grade balance charger to obtain storage charge for each battery of the same type after you have finished flying as it thus makes it easier to parallel charge next time around. Dependant on your input power source and the number of batteries you wish to charge (maximum of 6) you may not have enough amps to charge even at 1C so reduce the number of batteries or charge at lower amps, either way, you will still save time. I normally charge 4x 2200mah lipos at the same time but my power source can only provide (6amps) I would need to supply (8.8amps) to charge at @1 C so I simply charge at lower amps say for example (5amps). The product is well made well at least the one I received is I checked it out thoroughly and it's fine. This is a parallel charging board so all the XT60 ports are connected in parallel and all the balance ports are connected in parallel so it doesn't matter which battery is connected to which ports only that the XT60 and the Balance are both connected from each battery to be charged. If you are a newbie to parallel charging LiPo batteries read the instructions better still go online and make sure you understand exactly what you are doing so that you stay safe.Read full review
Verified purchase: Yes | Condition: New
This is a good quality paraboard for the price, quality silicone wire and upon internal inspection all solder joints were very good with no bridging. It is VERY important that you strip and inspect any paraboard to check for dry solder joints and even worse, bridged solder joints that could lead to a serious lipo fire, This paraboard is a typical Chinese clone but I'm very happy with the quality for the price paid, if your on a budget then this will serve you well enough, I charge 6x 1300 lipos @1 C (7.8amps) which is the best way to charge but if your going to put some serious amps through it charging multiple lipos at 3-5c then you best go for a genuine Paraboard that will cost around £35-40 that has been fully tested with multiple fuses to handle high C charging, happy flying 😃
Verified purchase: Yes | Condition: New
this charger is very good at what it does plenty of warnings given by supplier for incorrect use a valuable piece of equipment that does its job well
Verified purchase: Yes | Condition: New
Not only charges 6x lipo but puts 6 into storage with my overlander charger.
Verified purchase: Yes | Condition: New
The board is well made, and does exactly what it is designed for.
Verified purchase: Yes | Condition: New