About
All Feedback (618)
- *****- Feedback left by buyer.Past monthVerified purchaseGreat communication. A pleasure to do business with.
- *****- Feedback left by buyer.Past 6 monthsVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer,prompt payment,value customer, highly recommended.
- bearings_express1 (1822)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended. Tracie
- secuvision (61)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- salescoinbattery (30564)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (16)
12 Oct, 2018
A Clever PWM Converter.
This module performs some very useful tasks in RC. For converting PWM based RSSI (EZuhf) into an osd friendly voltage gradient from 0-5v this module makes a simple inline solution. It can also be used to drive servo's with a pot, very useful for manually controlling antenna trackers or anything servo based that does not require a radio. The size is small enough to slip it inside some heatshrink once setup, and it is very lightweight. I can find no negatives about this product.
19 Nov, 2019
Best High Tech One Part Epoxy Glue Available
This glue is very useful for difficult materials. It shrinks on curing pulling the joint tight, and it remains flexible, so will not crack or release on many flexible materials like CA glue does.
It has a reasonable cure time, initially around 1 hour and reaching full cure within 24 hours, depending on materials. Porous surfaces will cure faster.
I use it mostly for RC construction, and it works on EPP and EPO foam with the strongest bond possible, the foam around the joint will break first.
I have stuck glass, titanium, aluminium, plastic, wood, foam and various other difficult materials like mylar and kevlar with great success. These smaller tube sizes are a long term benefit as I have large tubes that always go off before fully used, and a lot usually ends up wasted, so now I purchase these smaller tubes in greater numbers and it remains fresh.
19 Jul, 2018
Best bulk testing charger
1 of 1 found this helpful The performance of this charger is a standout with charge and discharge capability of up to 1 amp. It does a proper cell test with charge, discharge (log capacity) and then recharge. The default mode is to charge at 500ma, and some quick button presses soon gets all four cells under test. My only suggestion if it is being used for bulk cell testing is to place a small fan nearby blowing over the cells. Some liion cells will overheat when faulty, and at 1 amp the temperature can cause runaway. With some airflow over the cells it has prevented any of mine from rupturing or venting. I have processed around 500 cells so far, and my only negatives with this charger are: no cell temperature monitoring, occasionaly clunky mode setting, poor cell access for removal (requires hook tool) and no memory for momentary power disruption, it instanly reverts from testing to charging which can lead to mis diagnosed cells. So far its the best of the bunch that I've used and highly recommend it, taking everything into account.