About
All Feedback (919)
- 11tommy100 (1217)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- taskoutdoor (8717)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- airtacnt (4171)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
- junglehunter2016-3 (31557)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
- vonluxe (3459)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer,prompt payment,nice to deal with!
- maxi2512 (168223)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
Reviews (2)
20 Sep, 2018
Good value
The markings are nicely engraved, and accurate.
Straightness is decent, but not perfect and a little variable. Of the 2 rulers I bought, the worst edge has a crown of a little under 0.1mm from centre to end.
The cut at the zero end is a little off too. One ruler is cut about 0.2mm short, and the other about 0.25mm long. The short one will go in the sewing box where 0.2mm is of no concern, and the long one should be easy enough to file down to a perfect zero. The end cuts are within a degree or so of being square.
Of course these are a fraction of the price of a Starrett or similar rule, so you can't expect ultimate engineering precision. At the price they are more than adequate for most purposes and represent excellent value.
19 Feb, 2025
Disappointed with the quality of these c...
Disappointed with the quality of these castors. A poor design of the bearing arrangement in the hub means the bearings are excessively side-loaded when the axle bolt is fully tightened, making them hard to spin. The factory's workaround seems to be to not fully tighten the axle bolt, so the inner races of the bearings can spin on the axle, metal-to-metal. A solid plastic hub would be better than that! My fix was to add a spacer between the inner races of the two bearings in each wheel.