About
All Feedback (54)
- advantage-parts (30707)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- unitedtires (348147)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- pe-motorwerks (154160)- Feedback left by buyer.More than a year agoVerified purchasePrompt email reply and extremely fast payment. The Best! Thanks!! A++
- iwgh (1657)- Feedback left by buyer.More than a year agoVerified purchase.................Thanks
Reviews (6)
15 Nov, 2016
Great unit terrible manual.
4 of 4 found this helpful So far and I'm no expert the Cut 50 is up and cutting in about 2 hours. I'd have gotten it quicker if the paper pamphlet that is supposed to pass for an operating manual was better even just a little better. It couldn't be worse. I did end up going to a welding forum or two and found tha answer to the wiring of the power if you plan to run it on 110/120 volts instead of 220v. The green/yellow is ground and the other 2 wires don't matter. Either one can be "hot" or "neutral".
Getting it going was a bit sketchy for me as I've never used one before so my review is not exactly based on tons of experience. I've welded and used oxy/acetylene before but not plasma. Still I think for a person that's just doing some "garden art" as I call it this little $200 plasma cutter is going to serve quite well.
I'll try to update this review after I've used the Cut 50 for a few months to let you know if I'm still as impressed.
15 Oct, 2016
Good and fast
Carb showed fast. It was just what I needed. I only would have liked better direction or diagrams of the fuel line connections. It took a number of tries to plumb it correctly since my original lines had deteriorated to the point that they had all broken and couldn't be used as a guide to reinstall the lines on the new carb. YouTube to the rescue! Once I got the lines routed correctly I then wished the carb included the correct mixture adjusting tool like some others do because the carb will need adjusting now to run properly. The weed wacker does start now but won't stay running properly. I'm assuming that once I set the mixture properly the moter will run ok. If not I may edit this review, but I do think that's all it needs and I'll have the adjusting tool in a few days. (Amazon for that).
13 Jan, 2018
Expensive but no choice
Not much to say. I needed to replace the screen on this laptop, the only way to acquire one is to purchase the entire top cover, screen and all!! Not happy with