About
All Feedback (3,113)
- herbique27 (100)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- prettywildseeds (87777)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- happygreenshop (228452)- Feedback left by buyer.More than a year agoVerified purchaseA trusted and valued customer A++ of Happy Green Shop 🌱
- facaishu (36850)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- thechemistlive (82542)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- snugrugs (66241)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued SNUGRUGS customer, highly recommended.
Reviews (8)
05 Feb, 2022
A lot more taste
Excellent for an extra coating on Costco cooked ribs . The ultimate for injecting into shoulder
of pork ,cooking on number two on a gas cooker for 7 hours makes the best pulled pork you have
ever tasted . Can give any pork produces more special .
18 Oct, 2018
DIY how to build
No connections are provided ,but that is no problem . You will need 3 single 18650 battery holders
with positive and negative wires .Also you obviously will need 3 18650 battery
step 1 insert switch in the body (top right hand corner)
step2 insert circuit board (carefully making sure the switch locates properly
step3 with a small amount of super glue , glue the chrome perimeter to the base
step4 glue in the 3 battery holders side by side centralised vertically(they must be pointing in the same direction)
step 5 if say the positive end is pointing away from the circuit board then shorten to about 60 mm long
then solder them to a longer wire to reach the circuit board
step 6 twist the 3 negative wires together tin ,then solder to the negative connection
step 7 solder the positive wire to the positive connection ( which you joined in step 5)
step 8 insert fully charged batteries
step 9 clip on the lid
step 10 click once to check how much charge is in the cells . two fast clicks will turn on/off the light
step11 Enjoy
16 Oct, 2017
Tile grout paint
I mixed 3 teaspoons of Titanium Dioxide with a amount of water based varnish
until it was a pasty consistency. works perfect . best to apply with artists paint brush
I am going to try with other liquids like Acrylic for other applications