About
All Feedback (58)
- *****- Feedback left by buyer.More than a year agoVerified purchase٩(｡•́‿•̀｡)۶ Bon acheteur et paiement rapide.Merci ٩(｡•́‿•̀｡)۶
Reviews (4)
Yamaha XSR700 XSR 700 2016 2017 2018 Gilles Tooling Speedo Holder Speedometer
25 Oct, 2018
better, safer position for your speedometer.
Sits way better than the stock position. You don't have to look down anymore, which makes everyday riding so much safer.
When installed, make sure that the cable isnt touching the front light housing, as it could scratch down the plastic over time ( it did to me :/ ).
Other than that the installation was pretty straight forward.
01 May, 2019
Best earplugs I have used (motorcycling)
Best earplugs I have ever used for motorcycling.
All other plugs I have used in the past all shared the same problem; All engine vibrations and other low frequency sounds got amplified. So it always ended up sounding worse than not using any earplugs at all.
I could sometimes get it to work but I had to really push the plugs so deep that they were basically touching against my eardrum :D.
I recently learned that what I was experiencing was "occlusion effect". These earplugs however, are vented. Meaning basically they have a hole running through them which eliminates this effect completely. I didn't think that would do that much of a difference, but it really does.
It's obviously more complicated than a simple vented hole, but that is the basic of how it works :)
If you have had similar problems like me with earplugs, try this one out.
Pros:
* Works great
* Small, so it fits inside the helmet without touching the sides.
* A tube case included that can be attached to your keyring
* Save time putting them on. With my previous earplugs I had to fiddle around for minutes until I got a good seal. With these, I just popped them in and its good.
Cons:
Not that I have found.
21 Sep, 2018
Crash bars
Nice looking crash bars. Looks like they will protect the bike pretty well, if dropped. Combine this with a spindle kit and you are good to go.
Very easy to install. Took me about an hour. You will need a torque wrench to get the right amount of Nm when installing it. It is also recommended to use locktite.