About
All Feedback (153)
- elizalodge (100026)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- brownbrummie (5247)- Feedback left by buyer.Past yearVerified purchaseHope to deal with you again. Thank you.
- yearious (1997)- Feedback left by buyer.Past yearVerified purchaseThank you very much for your support and purchase, perfect buyer, immediately gave 5 stars positiv feedback, hope to do business with you again！
- rift_tools (16598)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- dr.abrasive (54562)- Feedback left by buyer.More than a year agoVerified purchaseThank you. Dr Abrasive Ltd
- aceparts_uk (1214383)- Feedback left by buyer.More than a year agoVerified purchaseThank you for your purchase with Aceparts, please shop with us again soon.
Reviews (4)
14 Feb, 2018
Lovely piece of equipment - once it is installed.
1 of 1 found this helpful Instruction book has one sentence in English and that recommends a professional fit the lift. Instructions after that by means of sketches. No screws included or even recommended sizes. I finished up using 10 x 2 3/4". Need access to the loft space to locate the rafters rather than trying to find them by making probing holes into the ceiling plasterboard from below. Two light fittings and a loft hatch meant there was only one direction the lift could be fitted. This meant the main geared shaft part had to fit along one single rafter not across two or three(possible problems here). This in turn required extra timber to be screwed onto the rafter as the fittings were wider than the rafter. To be able to fit the geared shaft across three sounds easier providing the spacing between the rafters coincides with the distance between the three separate fittings on the geared shaft. If not, extra timber is needed to widen the rafters. Would also recommend the use of drawing pins or blu-tac to temporarily fix the drilling template onto the ceiling in order to mark the holes for drilling
24 Oct, 2018
Pleased with the choice
1 of 1 found this helpful Certainly far cheaper to run than our previous conventional condenser dryer - utility room much cooler and less humid. A little on the noisy side but as I said it is in the utility room. Only other downside found so far is its reluctance to take dampish synthetics that have been outside on the line through to full dryness. Cottons no problem. Nicely made with a far better level of finish than our previous 'combustible' Hotpoint.
27 May, 2020
Saves time
Just what was needed to make cleaning the pond less hassle getting the syphoning to work.