About
All Feedback (4,352)
- c***g- Feedback left by buyer.Past 6 monthsVerified purchaseJust as described. Fast shipping. Careful packaging. Great value. Thank you.
- d***a (767)- Feedback left by buyer.Past 6 monthsVerified purchaseItem arrived exactly as advertised. Seller cared enough to include the factory original wiring and fasteners. Well packaged.
- a***a (106)- Feedback left by buyer.Past 6 monthsVerified purchaseAs Advertised, great seller fast shipping !!!!
- e***- (1500)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat Seller! Item as advertised. Repeat buyer. Rating A+
- n***l (253)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat ebayer - I had goofed on quantity (thinking it was a set of 4) - he immediately responded and made me good. Wonderful business ethics and great old Cougar guy.
- y***8 (239)- Feedback left by buyer.Past 6 monthsVerified purchaseWell packaged and fast shipping. Thanks!
Reviews (21)
19 May, 2017
Just installed it, so far so good!
Nice part, all new construction, comes with bleeder kit also! All machining is crisp with no flashing or buggered up threads.
28 Dec, 2017
Who know's what you'll get! NOT for a 1969 351W!!! 1970+ is just fine but it depends....
Here is why I do NOT recommend this part!!!!
This part does NOT work on a 1969 351W unless you change the crank pulley, water pump pulley, timing cover, timing marker, and the water pump....then the radiator.....
1969 balancer should have 3 pulley mounting holes, 1970+ should have 4 holes.
This part DOES fit 1970 and up 351W cars just fine!
UNLESS, you get a 302 part in the box like I did.....which doesn't fit any of the 351's properly.
Site pictures vary widely for this part, some clearly showing 1970 4 hole version, others showing nothing but one side shot which is NOT a 351W balancer. Not sure who made the mistake, but it is being spread like a bad case of.....spoiled beer.
Buyer beware!
05 Jan, 2016
All you can get!
This is one of those "replaces a few parts" ......parts! In my case, I am rating this low, as it is a smaller diameter than the original pulley, which decreases the spin speed.....which was my problem..not spinning out the water. This also doesn't just slide on like you would expect a good replacement part to fit. You will probably need to use a hammer and a wood block to get it on without damaging the motor shaft. I never installed mine....I eventually found a proper replacement piece, but it is discontinued part, and I got lucky. Otherwise, this is a good part, made well, and others have seemed to make it work. Just not for me this time........ If I have to do this again, I would need to use this piece!