flyinglotus1983 on eBay

About

Location: United StatesMember since: 19 Sep, 1999

Feedback ratings

Last 12 months

Positive15- positive Feedback in last 12 months

Neutral0- neutral Feedback in last 12 months

Negative0- negative Feedback in last 12 months

All Feedback (647)

globaldeals247 (11861)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
mtwyouth (376591)- Feedback left by buyer.
More than a year ago
Verified purchase
Great communication. A pleasure to do business with.
thrift.books (3915671)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!! ~Thrift.Books
booksrun (150943)- Feedback left by buyer.
More than a year ago
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
william101william (9398)- Feedback left by buyer.
Past month
Verified purchase
Great Buyer *****
packcap (105)- Feedback left by buyer.
Past month
Verified purchase
Very prompt payment. Thank you and enjoy!

See all Feedback

Reviews (2)

Douk Audio EL34 Vacuum Tube Amplifier Single-ended HiFi Power Amp Kit DIY 12W×2

30 Jan, 2018

Decent SET tube kit

If you're building the kit, head over to diyaudio and check out the Boyuu A9 thread. There are quite a few mods that have been been documented there. These mods will 100% improve the overall sound quality of the amplifier, and honestly they should be something that the manufacturer is providing. Before I implemented the mods, the output was noisy with a 60Hz hum, and was quite fatiguing to listen to. After the mods were performed, the amp sounds positively amazing. I've switched the tubes out as follows: RCA 5U4G diode, matched GE 6SL7 input triodes, and apex-matched JJ KT77 output tubes. I also opted for an Alps 100KAX2 100K ohm stereo input potentiometer with logarithmic taper Other mods that I did that probably didn't have as much impact on the final result: Dayton Audio poly input caps for the ones in series between input and output stages. WBT silver 4% solder in the signal path. Canare Star Quad shielded cabling for the input signal path. Dayton Audio insulated RCA jacks, and 100% of the kit resistors and caps were replaced with better spec'd versions from Digikey. Anyway, after everything above, this amp sounds amazing. Zero noise/hum, very well behaved, but the distortion is quite pleasant when you turn it up. 10/10 would DIY again.

Ten Leveling and Extruder Springs for Reprap Prusa Mendel 3D Printer

08 Sep, 2016

Goldilocks springs for your RepRap bed or extruder

These are perfect for a Wade's extruder or a standard heated MK2B bed on a RepRap.

See all reviews