About
All Feedback (270)
officenutltd (77382)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer
jclarkemarine (61104)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended. JClarke marine
jclarkemarine (61104)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended. JClarke marine
bolt-world (660438)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, from BOLT-WORLD
boystoysnthings2013 (96848)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
fordeight_rotagrip_ltd (57564)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
Reviews (9)
07 Jun, 2017
Good coil with flaws
The coil is a reasonable copy of the OEM part. One difference is that the screw and plastic surround at the HT output is slightly longer than the original. This meant that on my saw, a stihl 034, the module could not be correctly aligned with the flywheel without fowling on the saw casing. It might be a problem with any saw where the HT lead does a sharp turn to avoid the casing immediately after leaving the module. I had to shorten the screw and plastic and got it fitted. Another niggle is that the plug boot on the replacement has the HT lead coming out at an acute angle which does not route the lead well on my saw. The old lead had a right angle boot so I reused the old boot and lead. After all the faffing around it did work well. I would really give it 5/10 recommendation but it is the cheapest way to go if you don't mind a bit of bodging.
17 Oct, 2018
Quite pricy but good
I can't fault it so far. A bit pricey, but if it lasts, worth it.
06 Jun, 2017
Reasonable quality after-market piston kit
It seemed like reasonable quality and well finished. The ring gap needed no adjustment. It all went together easily , I would just say that the wrist pin was an easier fit than expected but not loose by any means