About
All Feedback (99)
- 1gramcm3 (29420)- Feedback left by buyer.Past 6 monthsVerified purchasePrompt payment at time of purchase. Thank you!
- *****- Feedback left by buyer.Past yearVerified purchaseGreat communication. A pleasure to do business with.
- mndealdad (472)- Feedback left by buyer.More than a year agoVerified purchaseThank you for your purchase!
- vipsellinguk (2155)- Feedback left by buyer.More than a year agoVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- vacuumdealz (2963)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you.
- arcane_1 (332)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication, fast payment, glad to be part of your first eBay purchase
Reviews (4)
10 Apr, 2019
It's already falling apart after only a few months
2 of 2 found this helpful I get it, it's a cheap spoiler, but boy is it cheap.
So, the "gloss" black is one layer of paint. No primer, no clear and very easily scratched. I planned on repainting it anyways, but I would have been very upset if I wanted to just put it on the car.
Next, it was slightly damaged from shipping, a gouge in the plastic, but again, it was fixable since I was repainting it.
Then, the hardware that comes with it is a joke at best. The screws are a half inch long, if that and the built in washers are too small for the factory holes so they just slip through. I had to go buy my own bolts and washers to secure the spoiler to the trunk.
Now onto the fit. The trunk has a curve to it, it is not flat on the top by any means. However, the bottom of the spoiler post is flat, so this leaves a gap in the middle where the post meets the trunk. The provided foam tape is not thick enough to fill that gap and water can get in the gap and potentially through the bolt holes and into the trunk. I rectified this with silicone to seal it all up.
Finally, it is a hollow, plastic spoiler and I don't know if its because this spoiler is more flat than the stock one or if it's the materials used to make it, but it wobbles horribly at expressway speeds. There's no way to prevent this short of adding a 3rd spoiler post in the middle.
Visually, on the car, it looks nice. But that is about it. So unless you plan on repainting it and you don't drive on the expressway, I'd skip this one.
Update:
The spoiler is starting to separate from the posts, which I'm assuming is from the wobbling at expressway speeds. Avoid this one.
15 Apr, 2017
They are nice, but don't quite fit 2012 Chargers.
First off, the quality of the materials used to make these are great, but... (There's always a but), they don't fit 2012 (and I'd assume 11, 13 & 14) Chargers right out of the box. There are 2 "nipples" on the back of the light and one of them makes contact with a section of plastic in the light recess on the rear facia. So you have 2 choices, either drill a hole into this plastic section so the "nipple" will pass through or cut off the "nipple". However, if you choose to cut the nipple off vs. drilling into the rear facia (even though you'll never see the hole once the lights are on the car), that "nipple" is for a screw to keep the LED strip inside in place. I opted to cut the "nipple" and just used some silicone to seal it up.
The next issue is that the plugs are really hard to get into the existing light socket, but that might be a good thing as you know they won't slip out.
The 3rd issue is that the socket won't turn to lock. So you can either roll the dice and let it sit, hoping it won't fall out and then allow water into the light or do what I did and use some electrical tape to keep them down.
Still, even with these minor issues, I still would buy these again. They look great when on and look stock once installed. Maybe 2012 is the only year that these don't fit quite right or maybe people are cool with drilling into the facia peices, but I did have issues.
18 Jul, 2018
Honestly, a really good mod
The front and rear strut tower braces really stabilize the Charger in turns and on expressway on ramps. The templates are spot on and the bars also look great.