Skip to main content

greg-1950

About

Location: United StatesMember since: 05 Dec, 2015

All Feedback (31)

fulleis (2172)- Feedback left by buyer.
Past month
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
fsasllc (189790)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
ganfeii1_4 (54015)- Feedback left by buyer.
Past 6 months
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
freeway33 (2149)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
resellhere (16064)- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
integritybooksales (7591)- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
Reviews (16)
KREG SML-C125-500 No. 8 S X 1-1/4 in. L Square Zinc-Plated Pocket-Hole Screw
13 Apr, 2024
Got the job done
I used these to attach extension jambs to an exterior door I was installing. Like pocket screws in general, they did a nice job of aligning and tightening the glue joint while the glue dried while leaving me with no exposed holes after the door was installed in the rough opening. Just as expected.
Milwaukee 48-59-2013 REDLITHIUM USB Charger & Portable Power Source Kit
24 Mar, 2023
If you depend on the Milwaukee headlamp, this will enable continuous use
I've owned the Milwaukee headlamp for a while and love it! The only issue is that it would sometimes run out of juice before the end of my day and I'd have to stop to recharge it. This extra battery and charger eliminate that problem. I can now use the headlamp until it dies and swap in a fully charged battery in a matter of a couple of minutes, including setting up the dead battery in the charger. I'm very pleased with this product and highly recommend it for the purpose I stated.
WIREMOLD LEGRAND V511 90DEG RACEWAY FLAT ELBOW FITTING, IVORY
15 Mar, 2022
Helped fix a safety hazard
I own a house that's about 100 years old. The side entrance into the kitchen did not have an adjacent light switch which meant that one would have to walk across a dark kitchen to turn on the light. This has always bothered me, but I finally came up with a solution as shown in the photos. I buried Wiremold underneath the door casing and surface mounted a switch box as the wall behind the box was filled with solid wood framing for the door and window. I now have a switch at each of the three entries to the kitchen. I had to cut up the elbows to fit in the space available, but that was fine with me. I'm very happy with how the project turned out, and these elbows were a key part. The first photo shows the door casing removed with the switch box and two elbows shown installed. The second photo shows the door casing, which was grooved to accept the Wiremold, re-installed. The third photo, taken from the position of the switch shown in the other two photos, shows another Wiremold installation for the same circuit at the kitchen-to-front room door which I mounted on a built-in bookcase in the front room. By replacing the existing switch with a 3-way switch, I can now control the kitchen overhead light from all three entries. I also added a 3-way circuit in the front room so I can now walk through both kitchen and front room from any door to any other door and turn the lights on and off as I go.