About
Reviews (20)
17 Jan, 2019
Very happy I thought of that
This is a tube bender, measuring the OD(outside diameter) of aluminum tube. This is what I have and needed. Pipe is measured by ID( inside diameter)
So, make sure you know what you have,tube/pipe from the start.
since I had never done this before and only one aluminum tube so no room for error. I marked the center of the tube w marker, placed it in center of jig, rolled it towards the hold clamp and marked it there. Then placed it in hold clamp and started bending. It ended up being almost perfect. Luck/Skill=you decide. Placed a 2'x3' carpenter square on it marked the long side and cut off 1/4"
16 Jan, 2019
VERY Nice Jack
I have a gravel work area. Up to now, I have been using like a 2 1/2 ton smaller trunk jack. I lug it over to the car, put it on a piece of plywood, and get down on my knees to line it up, and jack the vehicle up. Very tedious.
This nifty jack does away with most of that. I can roll it to the car, and using the wheels get it very close to where I want it. It does not need any support under it. Then I can adjust the handle to a comfortable position, and use air to raise the vehicle.
I have only used this a couple of times, but I am going to like this.
17 Jan, 2019
AWESOME product
I’ve used more expensive heat presses in the past and this machine works as good if not better. It heats up faster. It’s easy to use, and it doesn’t take up all of my desk space. It’s perfect for what I use it for which is shirts. I would definitely recommend