About
Reviews (10)
CTC 3D Printer - Dual Extruder - MK8 - Factory Direct Lowest Price- ABS/PLA
07 Jun, 2017
CTC 3D Printer.
Strangely, the machine came with only one spool pin though there are two holes cut in the back panel as you would expect for a twin nozzle printer. Upon querying, it was suggested that I print a second one for myself. Not good enough. This problem could be alleviated by the supply of injection moulded items which would be a considerable saving in time than to print the pins.
By far, the most inefficient thing was the cheap cast wingnuts onto steel threads which made it extremely difficult to accurately level the table due to the slack in the wingnut threads which eventually stripped.
Another problem that I had was that the printed model stuck to the blue tape on the table which tore when I tried to remove the model. I replaced the tape with 2mm glass held on with clips.
Having said all this, if the supplier should take note of my criticisms, the buyers would find themselves with a robust and efficient printer for the price.
31 Aug, 2016
NEW 5 PIECE CERAMIC COATED FRYING PAN SET RED WHITE NON STICK PYREX GLASS LID
I have been using these pans for some weeks and have found them to be really good. The ceramic surface is far superior to the old Teflon coated variety to the extent that you have to be careful not to allow the food to slide right out of the pan. They are that good, especially if you are cooking with an additional amount small amount of oil.
I like to shallow fry much of my food but have always had a problem with spatter from the food, especially at high temperature. The glass lids on the two larger pans completely eliminate this problem.
09 May, 2018
Oxygen concentrator
1 of 1 found this helpful This is a very good unit that completely eliminates my previous need for oxygen cylinders. It is simple to use, especially with the remote control and starts producing a full setting of oxygen within 2 or 3 seconds.
If necessary, I could even use it in my car with a cheap 200W inverter due to its low electrical loading.
The only criticism that I have is that the carrying handle aperture should have a moulded surface finish inside it as it is possible for fingers to slip off the smooth inner surface and cause either damage or injury if dropped on a foot but not a problem if aware of it.
Well recommended