About
All Feedback (923)
- nicmir_274 (41363)- Feedback left by buyer.Past monthVerified purchaseWelcome to our store, thanks for your support!
- preferential-shop (2631)- Feedback left by buyer.Past monthVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- uppityy (1285)- Feedback left by buyer.Past 6 monthsVerified purchaseThank you very much for your support and purchase, perfect buyer, immediately gave 5 stars positiv feedback, hope to do business with you again！
- avartek (163618)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- zenvella_hub (2138)- Feedback left by buyer.Past 6 monthsVerified purchaseHope to deal with you again. Thank you.
- d-h-w-e (79113)- Feedback left by buyer.Past 6 monthsVerified purchaseWelcome to our store, thanks for your support!
Reviews (5)
06 Jun, 2024
same as my indoor machine salter pro in black (£80 new)but prices shot up, this was 4 my garage so good enough , no scoop with it but just use the spa
same as my indoor machine salter pro in black (£80 new)but prices shot up, this was 4 my garage so good enough , no scoop with it but just use the spare filter to pack coffee down, came well wrapped and packed. working well no marks on it.
13 Nov, 2021
Updating from old boc 130 turbo mig 22yrs old and still going strong
Went for this as down to reviews and warranty, same as other £300 machine avail but no warranty with them, down side you pay an extra £35 +p&p for the stick cable which comes in the same box as machine bloody con there, other cheaper makes comes with it, no better QC control, I opened up machine as others said check insides, one new 8mm nut stuck in between components on circuit board and the back of the plastic euro plug a chunk broken off and loose in machine doesn't affect working it, the gas pipe comes with cheap made badly threaded brass connectors one split as trying to do up replaced with better one, digital clock for amps waste of time really as only shows while you're welding, fan is bloody noisy , not used stick side yet but mig side is better than old transformer mig for 0.75 mm car body repairs set on 0volts and 2.5 wire speed was good, a machine with 25 or even 20 amps would be nicer for thin panel work but 30amp seems the lowest for DIY budget machine, it gave good penetration and clean weld using 5% co2 argon mix , 0.6 wire , it will run fine on a 3pin plug for 99% of people using it for diy, If you were to be welding at 180amps then you 'may' have to go for blue 16amp plug ( like caravan ones) and a dedicated socket , l have blue to blue socket with 3pin plug for most diy work and can unplug blue plug with 3pin to plug into dedicated heavy blue extension cable when stick welding farm implements 5mm thick, hope review helps anyone.
01 Aug, 2025
The shafts are fine but the boots don't ...
The shafts are fine but the boots don't last long they split and perished in 18months 3000miles but it's quicker and cheaper to replace whole unit than mess around with boots.