About
All Feedback (1,218)
- onelink-mall (30816)- Feedback left by buyer.More than a year agoVerified purchasePERFECT EBAYER.Thank You.A++++++++++++
- szuar56 (17)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A++++++.
- hawksmotorsports (95422)- Feedback left by buyer.More than a year agoVerified purchaseThank you for an easy, pleasant transaction. Excellent buyer. A+++
- gritroutdoors (70290)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- grayhawk19 (23876)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick response and fast payment. Perfect! THANKS!!
- sfsfmarketsf1 (83225)- Feedback left by buyer.Past 6 monthsVerified purchaseGreat communication. A pleasure to do business with.
Reviews (10)
17 Dec, 2018
Good shooter, tight specs.
Very tight barrel to frame measurement on two different frames, would have preferred another 1 or 2 thousands, yes its that tight, I couldn't measure as the smallest gauge I have is .0015 and its less than that, but much better than too much so I wouldn't call it a negative. The throat is a little tight too, so much so I had to push down Lapua 105gr factory loads about 2 hundreds to even get them to chamber without crushing everything into the lands to close the action. I'd call this one a negative, as I wont be using Lapua 105 pills in my hand loads, and hoped I could use something that may be longer in comparison to the Lapua's. Now, all that said, it shoots those factory Lapua loads pretty darn good. Only have 70 through the barrel, and getting some good 10 shots groups sub moa, when i do my part anyway. The finish on the barrel is so nice its like a new car, you're scared to get the first mark on it. :-)
28 Sep, 2022
Works flawlessly, doesn't remove coating, no sticky brass
Tried RCBS and it stripped off too much of the brass coating and got stuck no matter how much lube I used. The LEE die however works flawlessly, and was even designed in a way that if a case were to get stuck it can be easily knocked out using the heavy extractor pin shaft.
30 Oct, 2017
Pin breaks easily
First IMI 7.62 pin bent, bad enough, but its not replaceable. stupid design.