About
All Feedback (1,169)
- _***r (348)- Feedback left by buyer.Past 6 monthsVerified purchaseQuick delivery, and just as described
- e***t (155)- Feedback left by buyer.Past 6 monthsVerified purchaseDecent cable ident rings, very convenient. Promptly dispatched.
- carpartsinmotion (1088261)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- c***t (2837)- Feedback left by buyer.Past yearVerified purchasePleasure to deal with you. Thanks
- mercedesbenzofnewcastle (137376)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued Mercedes-Benz of Newcastle customer
- i***d (756)- Feedback left by buyer.Past yearVerified purchaseGreat speedy delivery.
Reviews (13)
07 Aug, 2020
Good value and works. but DO NOT USE WITH A CHILD SEAT IN THE FRONT!!!!!
Great bit of kit but with a couple of caveats.
I bought this for my 2013 C Class Mercedes. I had swapped the seat cushions between driver and passenger as the drivers side had split.
At first I thought it was only switches but I opened it and found the circuit board has a lot of electronics on it so this is not as simple as I first thought.
It came with a seatbelt deactivator too which I needed as it basically tells the car someone is sitting on the front passenger seat all the time.
This comes with just the pins so you need to remove the pins from the old connector. NOT EASY!!
I also needed to change the switches on the inside of the unit so I had to break the seal. This is easy though.
The sequence I followed was.
1. Disconnect the battery as you don't want air bags going off.
2. Remove the pins one at a time and insert corresponding pin from this adapter.
3. Do the same for the seat belt connector.
4. Reconnect the battery and test it.
5. Open the box as point 4 did not work.
6. Follow the instructions to change switches until it works.
The caveats.
1. The front airbag is now active all the time. You MUST NOT put a child seat in the front.
2. It was a total pain to remove the pins from the old connectors, have some good swear words ready.
3. The passenger seat belt warning is now deactivated so make sure your passenger puts their seat belt on. Remember the driver is responsible for his/her passengers.
Total time to fit was around an hour as it took nearly 30 minutes to get the first pin out.
21 Mar, 2018
Works OK but looks terrible around the edges
I knew this would be a bit smaller than the screen because of other reviews but was surprised nobody else mentioned the fact it looks awful. It seems the G5S Plus has a slight curve at the outside edges of the phone and this screen protector can't follow the curve as it is made from flat glass. This leaves an unsightly bubble effect right round the edge of the screen protector. I gave it 3 stars as it is well enough made and does the job. I also doubt if any other glass screen protector will be any better but I will be looking for another way to protect my phone.
01 May, 2018
Seems to work well
1 of 1 found this helpful I bought this to test lithium Ion batteries and it seems to work well. You set the desired bottom voltage with the + and _ buttons and press OK. It constantly scrolls through the voltage, current draw and accumulated mhr as the battery is discharging. When it reaches the preset voltage it stops discharging and shows the total mhr.
My only concern is the resistor gets extremely hot so it might be worth replacing it with a higher wattage one if using this for lots of batteries. They send a spare resistor with it so that would indicate they don't expect it to last long.