1.9K items sold
32 followers
Contact

Shop by category

    About

    Location: United StatesMember since: 21 May, 2003

    All Feedback (1,269)

    • c***. (191)- Feedback left by buyer.
      More than a year ago
      Verified purchase
      Received as advertised; packaged very well; satisfied with purchase.
    • 1***7 (105)- Feedback left by buyer.
      More than a year ago
      Verified purchase
      The item I ordered is exactly as discribed, arrived ahead of schedule
    • h***e (208)- Feedback left by buyer.
      More than a year ago
      Verified purchase
      just like he said, arrived on time, thanks so much
    • o***o (2291)- Feedback left by buyer.
      More than a year ago
      Verified purchase
      Fast shipping and good deal. Thanks.
    • l***l (1664)- Feedback left by buyer.
      More than a year ago
      Verified purchase
      Product was as advertised A+
    • -***i (1725)- Feedback left by buyer.
      More than a year ago
      Verified purchase
      Item as described.
    Reviews (4)
    Foot Operated Air Pump For Ball Bike Bicycle Tire Inflator Inflatable Mattress
    15 Mar, 2016
    Good value manual air pump
    Everything worked as listed. The only issue was the nozzle which hooks up to the tire vale was a bit tight so when you released the nozzle it was slow in coming off so some of the air leaked out. A little oil and pumping a few extra pumps before diconnecting the nozzle solved the problem.
    rc power supply 575watts 47amps icharger turnigy chargers,get 2 run in series!
    01 Aug, 2017
    Output wires for bullet connector.
    A good power source for RC chargers requiring high amps. If you plan to constantly draw 40 amps or use mutiple high output chargers be sure you use at least 12 gauge wiring anything smaller and the wire can get hot. I am running 3 high out put chargers and use 10 gauge wire from the power supply to the three way spliter after that I use 12 gauge wire to the chargers. Fan is constantly on which I like because I charge large 6S lipos and I've seen a few thermostat failures which can cause the power supply to burn up.
    1 of 1 found this helpful
    Permanent Glass Ionomer Dental Cement Crown Bridge Veneer Cure Luting Adhesive
    21 May, 2016
    Instuctions for use needs some updating
    Mixing instructions are good. Application of cement to the crown and base of the tooth needs to dry. User needs to have something to bite down on to force the crown in place (a small paper towel rolled up to about the size of a cigarette), wait a few minutes for cement to set. Finally gently use a floss and pick to clean out excess cement. .
    9 of 9 found this helpful

    About

    Use this space to tell other eBay members about yourself and what you’re passionate about. Give people more reasons to follow you!1/1000