pacific_northwest_bound on eBay

About

Location: United StatesMember since: 11 Jan, 2000

Feedback ratings

Last 12 months

Positive50- positive Feedback in last 12 months

Neutral0- neutral Feedback in last 12 months

Negative0- negative Feedback in last 12 months

All Feedback (1,788)

fillermetalqueen (15779)- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
creality-official-store (5935)- Feedback left by buyer.
More than a year ago
Verified purchase
Great communication. A pleasure to do business with.
stepperonline (12996)- Feedback left by buyer.
Past month
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
nationalpartsdepot (20352)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
usnitbuy (15846)- Feedback left by buyer.
Past 6 months
Verified purchase
Hope to deal with you again. Thank you.
plasmadynusa (31506)- Feedback left by buyer.
Past 6 months
Verified purchase
Excellent Customer!! Super Fast Pay!! Thanks for your Business!!

See all Feedback

Reviews (3)

Heavy Duty Pipe Tube Notcher 3/4" - 3" Tubing Capacity & Angles up to 50 Degree

25 Sep, 2020

Very solid tubing notcher and heavy!!

Heavy duty and well machined. I did not see an issue at all with it. The shaft appears to be stainless steel and fits good in the bearing housing with no slop and turns very smoothly. Nothing binding or loose, just perfect. The shaft also lines up exactly in the center of the tubing groove, it cuts accurately on center if you use a good quality hole saw, no problem. Should last a long time too.

JQX-12F 2Z DC 12V 30A DPDT General Purpose Power Relay 8 Pin

23 Oct, 2017

Great price for these relays.

These relays seem well made. Initial measurements look consistent, ~75 ohms on the coil. The true test would be to see how many cycles they can do before failure, I'm not set up to do that but they look good enough to use for my purposes.

1 of 1 found this helpful

160 Amp Stick ARC DC Inverter Welder 115/230 Dual Voltage Input Welding Machine

01 May, 2017

Great little inverter machine for the price

So far I've run 3/32" 6011, 3/32" 7018 and 1/8 7018 on this without any issues. The 1/8" 7018 was used with some 1/4" plate and 1/4" wall tube at 130 amps. That ran very smoothly. Restrikes with 7018 were very easy, most of the time I didn't even need to knock the flux off the electrode tip to restrike. When using a new electrode, I did have issues with the rod sticking on first strike. I found that if I held the electrode a few inches up with the other gloved hand until the arc was going, I didn't have that issue. They didn't seem to stick on restrikes. By the way, this is not a machine issue at all, this can happen with any machine. I've seen the inside of this machine and it's actually pretty well built. Amazing how well it performs for the price.

15 of 15 found this helpful

See all reviews