About
All Feedback (610)
- flowerm2c- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended
- b.p.r-trading (452894)- Feedback left by buyer.Past yearVerified purchaseFast payment, great communication, excellent buyer A+++
- excalibur_retail (205942)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- powertoolcentre (462474)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- getwaysky (208744)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- petrolscooter (578348)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
Reviews (3)
11 Dec, 2011
Superb bit of kit. Simple,fast and takes superb photos.
Superb camera. I already have an ixus 95is, this is basicly the same camera with a slightly bigger screen and no optical view finder.
Incredibe fast start up, small and slim and takes superb photos. I turn the resolution down to 6mp. Its faster and there is no need for more resolution for general snaps. Battery lasts 100's of snaps. Superb simple to use camera.
11 May, 2020
Superb. No complaints.
Almost exact copy, Fitted, primed and started second pull. Tick-over pretty perfect. Had to adjust the 'H' High rev needle jet to get it singing. (just a twiddle, about 1 1/2 turns in with a small flat head screwdriver) to get it running sweetly and on full song. Absolute bargain. Cheaper than a rebuild kit and about a three times cheaper than a genuine item. (The original was flooding and draining the tank when not in use and a pig to start). For an Echo HC-2400. It arrived in about two weeks! Very Happy Bunny.
22 Sep, 2019
Fixed dripping head and leak behind dial. So easy to fit. Like Lego, with a few screws.
Manufacturer original part in box, with instructions, New modified part and hub and silicone grease.
Could be fitted in 5 minuets if you where in a hurry. So simple. Bit like Lego, with a few screws.
Fixed my dripping shower and leak from behind the on/off dial.
This is a manufacturer modified part and is an exact fit. But does operate with about 50 degrees more rotation than the original before it hits the red button stop.
I took my time and descaled and cleaned all parts and inside the valve body housing. Cleaned the 2 rubber 'O' rings inside the cover, lubed with some extra silicone grease. But that is probably not necessary.
Follow the instructions exactly and you cannot go wrong. The new cartridge has no built in stops and uses a modified hub to control stop points. Very important. There is a small white arrow on the exit port that must point to the cold inlet (labeled). This will mean the flat on the spline will either be directly south or north.
All you need to fit is a small flat blade screwdriver to remove the dial centre cap (from the bottom of cap). A Pozidriv 2 (cross head screwdriver): 3 screws. and a largish flat head screwdriver. 4 screws.
I would recommend to take photos when taking to bits at each stage, especially of the adjustable temperature stop location. I put mine back exactly where it was and all is fine. No further setting up required. (all parts mentioned are clearly labeled on a diagram in the instructions). You cannot really go wrong. Make sure you turn the water off! or isolate the feeds to the shower unit. Switch your combi boiler off if you cannot isolate the feeds to the shower.
So simple, as I said. Bit like Lego with a few screws. If you can turn your water off, you can fit this part.
D.