ralph_alcala on eBay

About

Location: United StatesMember since: 07 Nov, 1999

Feedback ratings

Last 12 months

Positive4- positive Feedback in last 12 months

Neutral0- neutral Feedback in last 12 months

Negative0- negative Feedback in last 12 months

All Feedback (136)

alll4trade (105646)- Feedback left by buyer.
Past 6 months
Verified purchase
Thank you for an easy , pleasant transaction, Excellent eBayer A++++
liftstrutstore (110276)- Feedback left by buyer.
Past year
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
ym_aftermarkets (6920)- Feedback left by buyer.
Past year
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
mirror-zone (3726)- Feedback left by buyer.
More than a year ago
Verified purchase
Thank you for an easy, pleasant transaction. Excellent buyer. A++++++.
*****- Feedback left by buyer.
More than a year ago
Verified purchase
Good buyer, prompt payment, valued customer, highly recommended.
autobrother (30494)- Feedback left by buyer.
More than a year ago
Verified purchase
Hope to deal with you again. Thank you.

See all Feedback

Reviews (4)

Hood Release Cable Dorman 912-030 fits 84-96 Chevrolet Corvette

17 Dec, 2015

Almost perfect fit, but....

Seems typical of Chinese products......almost correct, the inner cable is slightly too short to allow proper adjustment. The one I installed just barely allows the hood latch to catch on the hood. hopefully the cable will stretch over time and that will allow better latching. Yes, it has an adjustment on the cable end, but fully at the stop now.

Remington SP-69 Foil & Cutter Blade Replacement Fits Microscreen MS2 Shavers

07 Nov, 2018

If you need it, buy it

Be careful when you remove and replace screens. If you break the plastic housing you will need part # RP00116

32mm Fan Clutch Nut Wrench Water Pump Holder Removal Tool Kit Fit for BMW

22 Oct, 2020

Adequate tool but not easy to loosen the fan nut on first try.

the 32mm fan clutch needed a very slight filing to fit on the nut of my BMW. I could have tapped it on but was afraid I would not get it off, so I filed a couple thousandths off. the holder tool needs a little bend to fit in tight quarters. The tool works but not as easy as I would have liked. Slip the tool on the nut and smack it with a hammer, you may not need to use the water pump holder tool if your serpentine belt has enough tension. You will curse a few times....but be patient and it is possible. Remember it is a reverse thread, clockwise loosens it.

See all reviews