rays9336 on eBay

About

Location: SwitzerlandMember since: 12 Dec, 2005

Feedback ratings

Last 12 months

Positive9- positive Feedback in last 12 months

Neutral0- neutral Feedback in last 12 months

Negative0- negative Feedback in last 12 months

All Feedback (771)

zygj001 (6488)- Feedback left by buyer.
Past month
Verified purchase
good buyer ! Welcome to shopping again !
chongsu_2 (303)- Feedback left by buyer.
Past month
Verified purchase
Good Buyer. Patient and gentlemen. Fast payment .A
haoyao002 (172)- Feedback left by buyer.
Past month
Verified purchase
Good Buyer. Patient and gentlemen. Fast payment .A
pc-industries (39148)- Feedback left by buyer.
Past month
Verified purchase
Quick response and fast payment. Perfect! THANKS!!
seb-enterprises (5818)- Feedback left by buyer.
Past month
Verified purchase
Great communication. A pleasure to do business with.
idealcosmetics (12606)- Feedback left by buyer.
Past 6 months
Verified purchase
Quick response and fast payment. Perfect! THANKS!!

See all Feedback

Reviews (20)

IGUS 10mm linear bearings, plain bearings, linear guide for 3d Printer, Linear Bearing

27 Nov, 2019

Top Quality

Top quality for 3D printer X and Y bars

GT2/2GT open Synchronous Timing Belt Width 6/9/15mm Small Backlash 3D Printer

10 Jun, 2018

Belt for Prusa

Good quality belt to beef up your Prusa-style 3D printer.

Anycubic TriGorilla Integrate Mainboard 4Layers 3D Printer PCB Controller Board

12 Oct, 2018

Good for testing firmware on 3D printers

Has same functionality as other chinese SBC (arduino mega + RAMPS1.4) mainboards. I used it to test some firmware changes without flashing my Raiscube A8R mainboard. Limit switch and thermistor connectors were incompatible, of course (it does not have to be better, just different). Power connectors are only 5Amp, which means you should use an external MOSFET unit to power the hot bed, otherwise this Trigorilla mainboard will emit white smoke and die. Luckily the Raiscube A8R stepper drivers are set to deliver 0.3Amp. If your steppers need more than 1.5Amp for each axis, expect more white smoke.

See all reviews