About
All Feedback (4,498)
- r***h (94)- Feedback left by buyer.Past 6 monthsVerified purchaseFantastic experience all over. The packaging was thoughtful and careful. Everything was protected. The item took hardly any time to arrive and is exactly as described; the camera and the lens work perfectly. It is all unscathed. Great price, amazing seller, will use again in future.
- i***g (1686)- Feedback left by buyer.Past 6 monthsVerified purchaseFantastic item. Well packed and super postage price and just a described .Great value
- 1***r (225)- Feedback left by buyer.Past 6 monthsVerified purchaseItem arrived as described well packed and 8n good time.
- i***l (1180)- Feedback left by buyer.Past 6 monthsVerified purchaseExcellent service very fast delivery and very well packaged
- 1***g (64)- Feedback left by buyer.Past monthVerified purchaseVery quick arrival and as described many thanks
- 1***2 (537)- Feedback left by buyer.Past monthVerified purchaseItem as described and well packaged, thanks.
Reviews (28)
11 May, 2018
Simple piece of kit
Just make sure you have a tester.
Easy to wire great seller
12 Jun, 2024
Nice quality
Nice quality
14 Mar, 2017
Its like cake making
7 of 7 found this helpful As my title .. Make sure you fully flush the system no matter how clean or dirty good preparation is the key to any task. If system was flushed add product first then top up with coolent and bleed system to your Haynes manual if you find it hard to bleed make your filler hole higher than the heating pipes by using plastic bottle with bottom cut off and place in either rad or coolent expansion tank then top up with are valves removed till coolent runs free then replace.
Make sure you get the engine to running temp even if you have to hold the revs for a few minutes this could take an hour THEN THIS IS IMPORTANT Let car tick over for another 30 to 45 mins. This will make the steel seal do its job properly then switch the car off and leave to cool down to cold .
Before you restart the car e.g ... Next morning top up rad or expansion tank if needed .
I did my procedure on a free day as doing this properly can easily take a morning.
And remember you must let The car cool right down before using it on a run.
Once the coolent level has cooled right down and topped up if nessasary then you can drive as normal but keep the hard driving down for the first 100/150 miles.
Hope this helps