About
All Feedback (827)
- *****- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- saunsine- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, prompt payment, valued customer, highly recommended.
- cdyjwl008 (687)- Feedback left by buyer.More than a year agoVerified purchaseGreat communication. A pleasure to do business with.
- misterrbandsaw (10899)- Feedback left by buyer.More than a year agoVerified purchaseHope to deal with you again. Thank you, Mr. Bandsaw.
- *****- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- lqjuan99 (3089)- Feedback left by buyer.Past monthVerified purchaseGood buyer! Highly recommended!! +++++
Reviews (4)
22 Sep, 2017
Low Temperature Operation
2 of 2 found this helpful I am using this 2 of these drivers with NEMA 24, 8 wire, 4.2A stepper motors wired for bi-polar parallal operation setup for 32 microsteps i.e. 6400 steps/revolution.
I have recently run this set-up for 4 hours continuous operation on my cnc mill whilst measuring the temperature of the drivers and motors. The drivers reached a max temp of 27 degC and the motors peaked at 43 degC.
In my limited experience of stepper drivers these are by far the best I have used, but it should also be noted that these are genuine Leadshine drivers re-badged where as my previous drivers were cheap clones, ran very hot and didn't last very long in fact one burst into flames.
If/when I buy more drivers I will certainly buy these as they seem "to do exactly what it says on the tin".
11 Mar, 2021
M12 X 1 tap review
Cuts really well. I used to tap a custom thread.
18 Aug, 2017
DRV8825 StepStick Stepper Motor Driver
These stepper motor drivers work well, much better than the A4988 drivers, bigger current output and lower operating temperature. Temperature hardly rises if you disable them a few milliseconds
after a stepper motor move.