About
All Feedback (216)
- edisonola (1191)- Feedback left by buyer.More than a year agoVerified purchaseGreat ebayer. Would happily sell too again. Thanks!
- jkcomputerparts (157722)- Feedback left by buyer.Past monthVerified purchaseThank you for your purchase! We appreciate your business!
- watchingandwearing (20)- Feedback left by buyer.Past monthVerified purchaseGreat buyer! Prompt payment! Smooth transaction! Thanks!
- jewelersliquidation (5928)- Feedback left by buyer.Past monthVerified purchaseGlad we could help, appreciate your business
- ephemera02 (2285)- Feedback left by buyer.Past monthVerified purchaseHope to deal with you again. Thank you.
- mkrogersgoods (894)- Feedback left by buyer.More than a year agoVerified purchaseGood buyer, thanks!
Reviews (4)
01 Jun, 2016
Good value, but not perfect.
1 of 1 found this helpful This kit is a very good value, but you should not expect perfection.
Pros -
- Good fit
- Good color, texture is better than the picture shows.
- All pieces included, including shoulder buttons and Nintendo logo sticker
- Definitely worth price paid.
Cons -
- I had to use two screws from the original case. One for the cartridge slot and one for the battery compartment, because the included screws were oval-headed and protruded above the case surface a fraction of an inch. They prevented the battery from sitting flat and the cover from closing flush, and I am sure that a cartridge would have rubbed against the new screw. The original screws had flat heads.
- I had to trim a tiny bit of plastic from the inside edge of the display case frame.
Yes, I would buy again for this price.
23 May, 2016
Works well; a little thick.
Everything works great, easy to install, and the brightness switch lines up perfectly with the access hole/notch in the battery compartment.
However, I tried and tried and tried to position the female ribbon socket so that the case would close flush, but no dice. It is a half MM from being flush. And because it is sandwiched between the back of the LCD and the MOBO, there is no way to modify the case to accommodate it perfectly. I did use a thin strip of double-sided tape around the LCD opening to prevent dust from entering, but it is nowhere near as thick as the gap made by the ribbon connector. The case will close flush if you tighten the screws enough, but then the front of the system is NOT flat. I don't know about a stock/plastic lens, but I used a glass replacement lens and one corner kept popping up due to the unevenness. I loosened the screws a bit and had to secure the screen with superglue to get it to stay. Maybe I missed something...
That said - anybody else would not notice.
27 May, 2016
Definitely not a perfect match.
This yellow is not a perfect match to the dandelion yellow GBC. It is pretty obviously a darker shade. The material is also noticeably thinner than the original. I don't think that will affect it's performance, if anything the latch may last longer because the plastic is more pliable. Worth the price, though, unless you are going for perfection.